Introduction

If the screen of your Sony Alpha 6000 is damaged and needs to be replaced then this guide is for you. This removal process is susceptible to breakage due to the amount of force that may be required in removing certain components.

  1. 4lelWmLVGQGGTqKD
    • Make sure the camera is turned off by turning the switch to OFF.

  2. RMPOM5A5jakaH2m6
    • Flip the camera around to access the battery compartment.

    • Slide the battery compartment lock to the left to unlock it.

  3. ie2TWmxvesIi1ICC
    • Locate the blue latch that holds the battery in.

  4. f1nE4EXFAngCSkkv
    • Push the latch back to release battery.

  5. I4roq2LSfmLNeN1J
    • The battery can now be taken out of its compartment.

  6. ou5NWlmyGHkBJsEJ
    ou5NWlmyGHkBJsEJ
    mcmPMwkHDT4Nd1Wp
    • Locate and unscrew the two 3 mm screws on the bottom of the screen.

    • Pull the screen out from the top to reveal the two screws behind the screen; unscrew the two 3 mm screws.

    How do I reach the 2 screws behind the screen? Even my tiny screw driver bit can't fit in that gap =/

    Charles Kung -

  7. GZOaKPxquFtEn2Aa
    GZOaKPxquFtEn2Aa
    BjRpLglWbVKB2FyF
    4kuJU5ZE6MQrBEhU
    • Flip the screen so it is facing up and then have the bottom of the camera facing yourself.

    • Using a spudger, remove the larger back panel.

    • Flip the camera right side up and pull back the screen.

    • Remove the smaller black panel on the back of the screen.

  8. NBefL1uOpNknqd6H
    NBefL1uOpNknqd6H
    gRsCAkMKhnDpOWkH
    • Locate the small "H" shaped clip on the back of the screen.

    • Remove the clip with tweezers

  9. o6l5NTkYGmfZmsmY
    o6l5NTkYGmfZmsmY
    EhPayOmQuIMfgcdq
    OXCrtHX2nsx1nvM2
    • Flip the screen back so it is facing up and then have the bottom of the camera facing you. The yellow circuit board should now be exposed.

    • Hold down the yellow circuit board that the ribbon cables are attached to.

    • Using tweezers, remove the smaller ribbon cable. This may require extra force that could damage the ribbon cable.

  10. JJKJkWvoJqmblRnM
    JJKJkWvoJqmblRnM
    odpyjKxm64igJWD6
    • Remove the larger ribbon cable. This may require extra force that could damage the ribbon cable.

  11. KkKukdZVRdmwTFpZ
    KkKukdZVRdmwTFpZ
    BH5BcJwBjbjxYUdB
    • Using a plastic opening tool, separate the silver panel from the actual screen.

    • Carefully slide the ribbon cables through the narrow opening to fully remove the screen.

Conclusion

Now your screen is ready to be replaced! To reassemble your device, follow these instructions in reverse order.

Jennifer Vuu

Member since: 01/10/16

548 Reputation

0 comments