Sony ICF-C1iPMK2 Control Buttons Replacement

Written By: KyndleGabel

Comments: 0

Sony ICF-C1iPMK2 Control Buttons Replacement

Difficulty

Difficult

Steps

Time Required

20 - 40 minutes

Introduction

If you notice your Sony ICF-C1PMK2 clock radio does not respond when you push the buttons, this guide provides step by step instructions on replacing the buttons. The buttons allow you to turn up volume play and pause the music etc.

Tools

Step 1

Remove the 1 cm Phillips #00 head screws.
Use a plastic spudger to pry the back chassis away from the front.

Step 2

This step contains ribbon cables. Be careful to not bend or rip these fragile cables, to protect your device.
Open the back chassis.
Remove the top ribbon cable by pulling it straight out of the port.

Step 3

Disconnect the power connector.
Disconnect the AUX port connector.
Slide the buttons out of the front chassis.

Step 4

Remove the 1 cm Phillips #00 screws on the board.
Pull the plastic buttons off of the housing.

Step 5

This next step requires soldering. Be careful when handling a soldering iron as you can easily burn yourself on it and the hot liquid solder. Make sure to desolder and solder in a well ventilated area to not inhale heavy metals, possibly lead. (If you buy iFixit solder there will not be any lead in the solder, but it is still best practice)
Place the soldering iron onto the solder joint of the broken button.
Once melted, remove the button, being careful to not touch the melted metal.
Replace the button and touch the soldering iron to the solder wire over the button contacts. Refer to the prerequisite guide if you need more help.

Conclusion

Give the new solder 30 to 45 seconds to cool before reassembling.

To reassemble your device, follow these instructions in reverse order.

Author

KyndleGabel

Member since: 15/09/23

533 Reputation