Sony SRS-X3 Battery Replacement

Written By: Seth Taylor Rollins
  • Comments: 4
Sony SRS-X3 Battery Replacement

Difficulty

Easy

Steps

3

Time Required

5 - 10 minutes

Introduction

  1. GQNLQPXnARkIICBX

    • Remove the 6 philips head screws using the PH1 bit.

  2. EWMBfGrAUPdBqIel

    • Remove the 3 philips head screws holding in the green circuit board

  3. RSOjDnaDkoVR4usp

    • Unclip the battery pack and replace it with another one.

    the flat cable being short might disconnect.

    If so reconnect the flat cable then connect the battery

    sylvain erdman -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Seth Taylor Rollins

Member since: 17/01/17

245 Reputation

3 comments

Can you give the battery # on this please

Dan Clark -

Good instructions. I had one problem when removing the green circuit card. The ribbon cable came out. On mine there was a small black retention bar that I flipped open to allow the ribbon cable to reinsert, then I returned the retention bar back down to secure the ribbon cable in place. It worked fine after that.

Harpo -

It would be nice if the article addressed the 6 rubber pads that cover the screws. There doesn't seem to be a way to remove them without damaging them, and you need them in order to use the speaker without it rattling and moving about from vibrations.

Peter Nosko -