Supersonic SC-777BT Touchscreen Sensor Replacement

Written By: Payton Butler
  • Comments: 0
Supersonic SC-777BT Touchscreen Sensor Replacement

Difficulty

Moderate

Steps

3

Time Required

5 minutes

Introduction

If your touchscreen does not respond to a finger or stylus, you need to replace the touchscreen sensor. As a prerequisite, use the motherboard replacement guide to reveal the touchscreen after opening the back.

  1. nrDs344ApsIqZaDo
    nrDs344ApsIqZaDo
    CcP1xhWrI2C1yE1D

    • Pull the yellow ribbon cable to dislodge the screen from the plastic screen cover.

  2. gmMwmPa4jPCTJ3ef
    gmMwmPa4jPCTJ3ef
    WdOmNPuHbD1UUQdv
    QQaUKHO1FwlCBGeG

    • Tear the yellow tape in order to make the front and back covers free to disassemble.

  3. 4qCsUmqTtQPSTRF3
    4qCsUmqTtQPSTRF3
    tEJgFp6aWcpTbPyl
    XT6t1Zn5luGEfKCO

    • Separate the two covers.

    • Put aside the white sheets.

    • Do not put the white sheets on any surface. Only keep them in the covers.

    • Use the tweezers to remove the sting glue and separate the glue from the sensor.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Payton Butler

Member since: 18/09/18

205 Reputation

0 comments