Tineco FLOOR ONE S3 Breeze Battery Replacement

Written By: Seth Bowers
  • Comments: 0
Tineco FLOOR ONE S3 Breeze Battery Replacement

Difficulty

Moderate

Steps

5

Time Required

20 minutes

Introduction

The Tineco FLOOR ONE S3 Breeze (model no. FW007600US) will sometimes have charging issues with the battery, and this causes it to become less efficient over time, which may result in the need to replace the battery. This replacement guide shows all the steps required to replace the battery and get the vacuum back in operation.

  1. Rvj2vaqfKP33ctlN
    Rvj2vaqfKP33ctlN
    YF1MTs4xCWwdEbvT

    • Remove six 10.6 mm screws from the back of the vacuum with a Phillips #1 screwdriver.

    • Remove the entire back piece.

  2. Ld4kZYDXZB15lEcI

    • Remove four 10.6 mm screws from the remaining white back piece with a Phillips #1 screwdriver.

  3. sVAFWErYuAC1dLik
    sVAFWErYuAC1dLik
    vDRPturKZ6ZqXQUP
    nkRHZmmP3VToHvc5

    • Pry open and remove the black ring at the top of the vacuum using by using an opening tool.

    • Remove four 10.6 mm screws located underneath the previously pried ring using a Phillips #1 screwdriver.

    • Remove the top circular piece from the body of the vacuum.

  4. HSLNEMvx5TbtShLr

    • Remove the white back piece of the vacuum.

  5. DSZt4W2HqAotw3LV
    DSZt4W2HqAotw3LV
    vYJEvbLXyO1SOFpj

    • Unplug the wires of the battery by carefully pulling them up from the motherboard.

    • Slide the battery out of its slot and replace it with the new battery.

    • The connection may be difficult to remove. Be careful not to rip the entire connector from the motherboard.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Seth Bowers

Member since: 14/02/24

220 Reputation

0 comments