Introduction
The error F6/E77 means that the machine has detected water on the bottom of the housing.
-
-
Error F6/E77 means that the machine has detected water on the bottom of the housing.
-
If the error cannot be acknowledged by pressing the >> button, you must remove the water from the bottom of the housing (and probably find and seal a leak)
-
-
-
Remove all water if any has accumulated in the lowest part of the machine
-
The "leakage water sensor" consists of the two contacts circled in red: If there is an electrically conductive medium (e.g. water) between these two plugs, then the error F6/E77 is displayed. So dry the contacts and the areas around the plugs. Of course, the motor must also be dry.
-
Try to identify any leaking areas and fix them (not part of this instruction)
-
-
-
Reattach the bottom cover to the device
-
Reconnect the power cable (but not the water)
-
Close the door of your washing machine. If the error F6/E77 is still displayed, acknowledge the error by pressing the >> button
-
If the error persists, let the machine dry out completely for half a day - if the error cannot be acknowledged even then, you will most likely have to replace the control board
-
-
-
Now open the water supply tap: If the error occurs again, then you have a leak in a hose somewhere or the middle separation of the tub is leaking
-
To reassemble your device, follow the steps in reverse order.
