Whirlpool Refrigerator - WRS588FIHB Control Board Replacement

Written By: Matt Zieminski
  • Comments: 1
Whirlpool Refrigerator - WRS588FIHB Control Board Replacement

Difficulty

Moderate

Steps

7

Time Required

No estimate

Introduction

  1. GAB31IUS1UwNdE6E

    • Before you begin your repair, perform the following:

    • Turn off your main water supply

    • Unplug your device

  2. SYZt1J6m6HjBsin2
    SYZt1J6m6HjBsin2
    NdAKltEPniudWBAJ

    • The dispenser panel screws are located under the dispenser as if you're looking up into the dispenser tube (where the ice cubes and water come out).

    • Remove the screw(s) securing the two dispenser panels.

    Does anyone know the part number for these screws? My refrigerator was delivered without them and the panel keeps popping off!

    Dan Austin -

  3. qiGV1bA5RtGmGPQT
    qiGV1bA5RtGmGPQT
    Hm1pGJiPHQiYPVCf
    YdGtVvWoV1AIyYST

    • Pull the dispenser panels straight down to separate them from the chassis.

    • Remove the dispenser panels.

  4. YsdojtqfDF1RGWfo

    • Remove the screw(s) securing the control board.

  5. YHIacodZZUISsUaF
    YHIacodZZUISsUaF
    XXEOSqpBQUixpFAD
    LcnTsAyBqRtZWUrV

    • Tilt the bottom of the control board away from the chassis to release its clips.

    • Pull straight down to separate the control board enough to access its connectors.

  6. upRbjNMvTVMwocdK
    upRbjNMvTVMwocdK
    Vdjv4STbceyM4Fcj
    ZttUHZrZMyADZ4qE

    • Disconnect the connectors attached to the control board.

  7. WNEDRxMM6WoUZExF

    • Remove the control board.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Matt Zieminski

Member since: 23/02/15

41355 Reputation

0 comments