Wyze WVCR200s Brush Roll Replacement

Written By: Brendan
  • Comments: 0
Wyze WVCR200s Brush Roll Replacement

Difficulty

Easy

Steps

3

Time Required

5 minutes

Introduction

Follow this guide to replace the rotating brush from your Wyze WVCR200s robot vacuum. The rotating brush is a part of the vacuum that will need to be taken out to be cleaned regularly.

  1. FoyShLOZvyECYMf1

    • Flip the vacuum upside down so the bottom is facing up.

    • In the center of the device, you should see the rotating brush that stretches from one wheel to the other.

  2. THLxWTAH4CJEODpC
    THLxWTAH4CJEODpC
    qeL42iOBKDfaWhbH

    • Pinch the blue tabs below the rotating brush towards each other.

    • Lift the plastic housing surrounding the rotating brushing straight up, and the remove it from the vacuum.

  3. SwKLSahCwuqiTLub
    SwKLSahCwuqiTLub
    NxDcHTN3RmecsTeb
    LUdeQe16dmABWCIm

    • To remove the rotating brush, lift one end of the brush upwards, and remove.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Brendan

Member since: 20/03/23

181 Reputation

0 comments