iRobot Braava 375t Fluid Reservoir Replacement

Written By: Diego
  • Comments: 0
iRobot Braava 375t Fluid Reservoir Replacement

Difficulty

Easy

Steps

3

Time Required

5 - 10 minutes

Introduction

The fluid reservoir in the iRobot Braava 375T is a compartment filled with the cleaning solutions used in cleaning hard surfaces. If fluid is leaking from the component, or an excess amount of liquid is coming out of the device, then the fluid reservoir may need to be replaced.  This guide will cover the steps to replace the fluid reservoir in the iRobot Braava 375T.

  1. Y6dkWeNFGIqoaYaA
    Y6dkWeNFGIqoaYaA
    SbHxosnLLqc25dwu

    • Begin by removing the fluid reservoir from the vacuum. To remove, lift upwards from the two buttons on each side.

  2. QEVd3jKGlTGoeeXw
    QEVd3jKGlTGoeeXw
    FRCJOiW2MasGuwHL

    • After removing the fluid reservoir from the device, turn the reservoir upside down and take off the cleaning cloth attached to the velcro strips.

  3. oRABdF1axVjCHwgo

    • Inspect the blue cap that is used to insert the cleaning solution. Determine if the rubber is damaged (holes, tears, etc.). Next, check the surrounding plastic area for cracks or deep scratches.

    • To temporarily fix cracks in the surrounding plastic area, apply a sealant like gorilla glue around the inlet of the blue cap. However, it's best to replace the whole reservoir to prevent further damage.

    • If damaged in any way, you can purchase a new reservoir from the iRobot website or similar sites such as Amazon or eBay.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Diego

Member since: 26/09/22

235 Reputation

0 comments