2015 Infiniti Q50 Seat Adjustment Switch Battery Replacement

Written By: Jonathan Ruvalcaba

Comments: 0

2015 Infiniti Q50 Seat Adjustment Switch Battery Replacement

Difficulty

Moderate

Steps

Time Required

45 minutes

Introduction

If the seat adjustment switch in your 2015 Infiniti Q50 is no longer functioning properly or has lost its ability to adjust the seat up or down, it is likely due to a dead battery, which will require a replacement.

A functional battery provides consistent power to the seat adjustment switches, ensuring that people can easily adjust seating positions for comfort and driving posture. If you notice that the seat switch doesn't allow you to adjust the seating position from seating up or down, you might just have a faulty seat switch. If the seat doesn't move even after buying a new set of seat switches, then you do have a faulty battery. You should change this as it allows the seat to be positioned precisely which allows comfort and safety.

Make sure to disconnect the car battery before you begin.

Tools

Parts

2015 Q50 Seat Adjustment Switch Battery

Step 1

Remove a total of four covers on the seat (two in the front and two in the back).

Step 2

Carefully remove both seat adjustment switches using a trim remover.
Don't force the seat switch out. If too much force is applied, the seat switch will get damaged.

Step 3

Use the impact wrench with a 14mm socket to remove the bolts securing the seat. There are two in front and two in the back of the seat.

Step 4

Remove both screws securing the plastic cover in front of the seat using a screwdriver.
Slide the cover to the right and remove the cover.
You may carefully lift the seat up and lean it against the back of the seats. This will make the process easier.

Step 5

Remove the screw holding the cover of the right side of the seat using a screwdriver.

Step 6

Remove the clip that is holding the cover using a trim remover.
Remove the clips from the back of the seat that are also holding the cover together.

Step 7

Slide the cover into the front of the seat and remove both screws using a screwdriver.

Step 8

Use a trim remover to remove all four clips that are holding the battery in place.

Step 9

Push the plug away from the battery and remove the seat adjustment switch battery.
Don't press too hard on the plug or force the plug out. The plug will get damaged and will not function properly if not careful.