Introduction
This guide will walk you through the replacement of the Eureka SuctionSeal Pet S Belt. The S Belt transfers power from the motor through a drive shaft and to the belt roller allowing it to spin when powered on. A damaged S Belt is a common issue causing the brush roller to no longer spin. If you notice the brush roller failing to spin and have already tried troubleshooting using this troubleshooting guide then this repair guide may help you.
Tools
-
-
Remove the four 19 mm screws using a Phillips #2 screwdriver.
-
Remove the vacuum head cover by lifting away from the vacuum head.
-
-
-
Starting from the bottom of the S belt, rotate the S belt away from the wheel.
-
Lift the S belt away from the bottom roller and remove from the motor shaft by sliding the S belt between the motor shaft and the vacuum head wall.
-
To reassemble your device, follow these instructions in reverse order.
